Services:
Tweed Renewables Ltd offer the following services...
Solar
water heating
The
hot water needs for domestic properties can vary greatly depending on
the occupancy. Tweed Renewables Ltd can perform an on site survey to
determine what volume of hot water is required daily and then tailor a
solar water heating system to suit. This will include solar panels,
heat transfer pipework, hot water cylinder, pump station and control
unit.
The
installation of a solar water heating system is an important step for a
home owner to take. You will be taking control of the money you spend
each year on your hot water heating bill. Either you invest in a solar
water heating system that gives you energy security (increasing fuel
costs will have less effect on your monthly bills) or you continue to
give money away to a utility company for an ever increasing service.
The installation of a solar water heating system will
typically take three to four days with minimum dissruption to your
current services.
Solar
water heating systems require very little maintenance. An annual check
of the anti-freeze based heat transfer fluid can be undertaken by the
home owner. It is good practice to have the anti-freeze changed every
five years.
Tweed Renewables Ltd are BPEC approved Solar Water Heating installers.
Solid fuel stove installation
Tweed Renewables can supply and
install your solid fuel stove whether it be a simple addition to your
living room or a major new heat source for your domestic hot water and
space heating. Please visit our solid
fuel stoves page.
Un-vented cylinder installation and service
Un-vented
water cylinders provide mains pressure hot water at high flow rates and
are ideally suited for domestic installations. If you are upgrading
your hot water heating system then why not combine your new un-vented
cylinder with a solar water heating system and get mains
pressure
hot water (up to 60% free). There is no need for a cold water cistern
(header tank) when using an un-vented cylinder.
Your un-vented cylinder requires servicing every year.
Tweed
Renewables Ltd are Logic approved Un-vented Hot Water Systems
installers and comply with section G3 of the current building
regulations.
Under floor heating
Underfloor heating provides the
most comfortable even warmth of any heating system. It is economical to
run and virtually maintenance free.
The system has water being
pumped from a boiler to a pump pack, where it is mixed to approximately
50ºC then distributed via a manifold to heating circuits made using
barrier pipe. The pipe is laid in concrete or suspended just below the
surface of the floor. In concrete floors, the pipe is laid on
insulation and then covered with a screed on which can be laid almost
any type of floor covering.
For timber floors, spreader plates are
laid between the joists and the floor decking or on the underside of
the floor. Pipe is pushed into the grooves on the plates.
The
floor area is typically warmed to between 25ºC and 28ºC, providing an
even distribution of heat at only slightly higher than room
temperature. The system is controlled by one or more thermostats which
signal the pump pack when heat is required.
General plumbing
All types of general plumbing work is undertaken from central heating
installation to bathroom installaton.
Architects
and Agents
Are
you looking to incorporate a solar water heating system into your next
project? Many local planning departments now require a proportion of
the energy required by a new domestic development to be contributed by
a renewable source. Tweed Renewables Ltd can offer advise or undertake
the design process as well as supply and install the solar water
heating system for your client. We can also install solar water heating
systems that have been fully specified and require installation only.
|
mob: 0775 690 9884
tel: 01721 724472
|